FANDOM


Do you possess room that may use a ceiling fan? Installing a ceiling fan is as straightforward as replacing your current light fixture. Every single piece of the wiring will already be around, so the only challenge will be replacing the existing workbox with one that is accepted for the weight of a ceiling fan. If you dont modify the established workbox to something that can cope with the weight could spell disaster. Before you begin your project, read the directions for the fan you have bought, and make sure that you have all of the needed tools.(View Identical Piece of Content: Follow Over Here)

Should you decide to make the fan on a cathedral ceiling, you must acquire an extension to ensure the fan wont be so high up. When you are completely ready to put in the fan, ensure that the circuit breaker is turned off so you wont get electrocuted. Eliminate the light fixture, and determine if the workbox that is already there can handle the extra weight. In many cases, the workbox is not going to be able to handle the extra weight so you may need further support. This is usually done rather quickly if you have entry to the attic, and are capable to get to the spot of the new fan. To be able to extra support, you nail a 2x4 in the ceiling rafters where it hits the top of the workbox. Check the 2x4 is anchored in its place, and then attach the box to the wood. If everything is performed the right way, the weight of the fan will now be fully supported by the wood and the screws. If you dont have access to the attic, you will have to place a cross bracing in your ceiling. It is more difficult to carry out and may not be that reliable but its the best option if you have no attic admittance.

When you have put together the fan carefully, you are now all set to hang your fan. The tough part is holding the fan, while hooking up the wiring. The challenge is according to the type of fan you get, whether it is a hanging frame or a fan that has a bracket with a J hook. Majority of fans have a chain to master the speed of the fan while the wall switch turns the unit on or off. If you choose to also install a light kit with the fan, both can be regulated by either chain or wall switch. Electrical wiring the fan is as easy as connecting two black wires, two ground wires and two white wires. Once you have finished putting together the fan and wires, the last step is to secure the fan blades. As soon as that is completed, turn the breaker back on to see the results. Thank you for reading this article and also remember to go and visit my other articles and reviews. If you are browsing for a great article about 18 gauge plugs, I suggest you visit my site.